Regency fireplace not responding to the remote, or the pilot refusing to stay lit? We provide Regency fireplace repair for homes across Snohomish County, from Arlington to Mukilteo, often on the same day. You get upfront pricing and approve the cost before any work begins.
















Regency makes many kinds of gas fireplaces, and homes use them in different ways. We are a local HVAC company that services them. See where we work on our service area page.
Every Regency has a model and serial label. We start there so the parts, fuel type and ignition system match your exact unit.
Many Regency fireplaces run on Proflame electronics. We pair, test and replace remotes and receivers instead of guessing at the gas side.
We explain what failed and quote the repair. Nothing starts until you say yes, so there are no surprises later.
Call (425) 225-4756 any hour. A real person picks up, and same-day appointments are often open across the county.
Regency sells inserts, modern frameless fireplaces, traditional units and stoves. Each family has its own quirks, and so does each ignition platform. Find yours below to see the faults we fix most often.
Liberty inserts are designed to slide into an existing masonry fireplace, which makes them a favorite in older homes around Edmonds, Snohomish and Everett. Tight enclosures hold heat, so blowers, seals and electronics work hard every season.
Blower noisy, weak or silent
Remote ignored by the insert
Faceplate gaps or loose trim
Pilot lights, main burner will not
A tripped limit switch is the usual cause, often after the blower slows or stops. We test the fan, check airflow around the unit and confirm the safety switch resets properly.
Often, yes. Many parts are reached through the front or lower access panel. If a part sits behind the unit and the insert must come out, we explain that before you approve the work.

City Series fireplaces are modern, frameless units with one-, two- or three-sided viewing, popular in newer homes and remodels. Their large glass fronts and sealed combustion make clean seals, healthy electronics and correct gas pressure especially important.
Flame height will not adjust
Glass hazed or cloudy inside
Ignition clicks without lighting
Receiver beeps but nothing happens
That points to a stuck modulating valve, a weak receiver signal or a remote that is out of sync. We test control signals first, then the valve, before suggesting any replacement parts.
Light fogging in the first few minutes of a cold start is normal. Persistent haze may mean a leaking gasket, dirty glass film or a combustion issue, so have it looked at.

Grandview units are traditional gas fireplaces built into framed chases, common in family rooms from Marysville to Monroe. Depending on the model, they offer electronic ignition or a standing pilot, and they pair with a wall switch or a Proflame remote.
Pilot goes out after a day
Wall switch has no effect
Logs smell or soot after lighting
Click, click, no flame
It might be. A weak thermocouple or thermopile, a dirty pilot hood or a low gas supply can each cause it. We meter the voltage and check pilot flame shape to find the real culprit.
It depends on the model. Standing pilot units can run without house power, while electronic ignition models need power or a battery backup. Your rating plate and manual tell you which you have.

Many Regency fireplaces use Proflame electronic ignition with a remote and a receiver. When one piece fails or loses its pairing, the whole fireplace seems dead, even though the gas side may be fine. We sort out which piece is at fault.
Remote shows a low battery icon
Remote does not beep when powered
Wrong pilot mode, IPI or CPI
Receiver dead with fresh backup batteries
If it does not beep when you power it on, it may be unpaired from the receiver. A re-pairing often fixes it. If not, the remote or the receiver may have failed, and we can test both.
Intermittent mode lights the pilot only when the fireplace is on, while continuous mode keeps it burning. Either can work. We can switch settings and explain how each choice affects your fireplace.


Call (425) 225-4756 or use the form. Tell us your Regency model, your fuel type and what the fireplace is doing.
We diagnose the fault, explain it clearly and quote the repair. Work begins only after you approve the cost.
We complete the repair, test the remote, the ignition and the flame, and walk you through the controls before we leave.
A Regency rarely fails without a warning sign. If you notice one of these, it is better to book a visit before the first hard freeze, when the fireplace is the room everyone wants to gather around.
Remote works only when held close
Pilot needs relighting every few days
Fireplace turns off on its own
Odd smell or soot after lighting
Smell gas? Touch no switches and light nothing. Leave, then call 911 or Puget Sound Energy at 1-888-225-5773 from outside. Stanwood and Arlington north of SR 531 use Cascade Natural Gas, 888-522-1130. When it is safe, call us.

Electronics, batteries and heat all age a fireplace. These small habits, done each fall, prevent most no-start calls on a Regency before they happen.
A Proflame remote and its receiver backup both take batteries. Replace both sets each fall with quality cells, since cheap ones drain quickly in a warm hearth.
If your receiver plugs into an outlet, check that it is still seated and that the breaker has not tripped. Power loss can look like a broken fireplace.
Take a photo of the rating plate and keep it on your phone. The model and serial number let us bring the right parts the first time.
Clean the glass only when the unit is completely cool, using a product made for fireplace glass. Never use abrasive pads, which scratch the surface.
Carbon monoxide cannot be seen or smelled. A cracked glass seal, a blocked vent or a poorly burning flame can cause it. Keep working CO alarms on every level and near sleeping areas. If one sounds, get everyone outside and call 911 right away.
Our annual visit targets what causes most Regency service calls. We clean the burner and pilot, test ignition parts and the receiver, inspect the glass and vent, and leak-check every fitting.
Want one visit without a plan? Call us or book online whenever it suits you.
We service most Regency gas fireplaces, inserts, stoves and log sets. Send us the model and serial number from the rating plate, and we will check parts availability before we visit. Own another brand too? Our techs also fix Napoleon and Heat & Glo units.
We serve homes across the county, including Arlington, Marysville, Everett, Lake Stevens, Snohomish, Monroe, Mill Creek, Lynnwood, Edmonds and Mukilteo. Our family-owned shop is based in Lake Stevens, close to most of them.
That usually points to the remote, its batteries or its pairing with the receiver, since the gas side responds to the wall switch. We test the remote and receiver and replace whichever has failed.
Some models can on battery backup, and standing pilot units run without house power. Check that backup batteries are fresh before storm season, and ask us if you are unsure about your unit.
Yes. Propane and natural gas units use different orifices and pressures, so a tech checks the rating plate and tests the gas pressure. We also service units on rural properties outside the gas mains.
Often, yes. Remotes, receivers, igniters, pilot parts and blowers can usually be replaced. If a repair does not add up, we will tell you plainly before you spend anything.

