- 100% Satisfaction Guarantee
- 0% Financing Available
- 24 HR Emergency Service
- 5-Star rating
Fireplace dark on a cold foothill night? We provide gas fireplace repair in Granite Falls for natural gas and propane units, from Old Town bungalows to homes out by Lake Roesiger. We find what failed, and nothing starts until you approve the upfront price.
Many homes here use their fireplace as real heat when winter storms knock out power. That makes a working one worth having, and a gas-trained tech worth calling.
City addresses may have a gas main, while rural homes often run on a propane tank. We repair both kinds of appliance.
We test thermocouples, pilot assemblies, valves and igniters, then replace only the part that actually failed, never a guess.
Licensed, bonded and insured, we check for gas leaks and confirm the flame burns clean before we pack up and leave.
As a full HVAC company, we can also look at a furnace or heat pump during the same trip.
Granite Falls homes range from 1900s houses with updated hearths to manufactured homes and new builds. Find your appliance below for the common faults and quick answers.
Older houses in Old Town often have a masonry hearth that now holds a gas insert. These units rely on a tight vent liner and a steady pilot to heat a room. Failures show up as a pilot that drops out, a click with no flame or a burner that quits.
Pilot that will not hold
Igniter clicks, no flame
Blower noise or no airflow
Vent or draft concerns
Usually the pilot is dirty, the spark is weak or a sensor has failed. We test the ignition circuit step by step so you only pay for the part that is bad.
On the first fire of the season, yes. If the smell lingers or turns sharp, shut it off and call us to inspect the venting.
A gas stove can heat a small house, a cabin or a shop apartment almost on its own. Because it sits in the room, you notice every cough, hum or shutdown. We repair the valves, sensors and fans that keep it steady.
Delayed or failed ignition
Fan humming or rattling
Flame lazy and yellow
Shutting off mid-evening
Heat-related shutdowns often point to a weak sensor, a limit switch or restricted airflow. We find which one is responsible and correct it so the stove runs through the evening.
Millivolt models usually can, since they do not need house power. Electronic models may need battery backup in place, and we can check how yours is set up.
A log set gives the look of a wood fire without the ash or hauling. It does need clear burner ports and logs placed exactly right. Yellow tips, soot on the logs or a pilot that will not stay lit are your cues to call.
Soot on logs or glass
Pilot keeps going out
Flame uneven or weak
Odd smell when running
Soot means the flame is not burning cleanly. Shifted logs, a dirty burner or a poor air mix are common causes, and we correct them.
Please do not. Placement controls how the flame touches the logs, and a wrong layout makes soot. We set them back to the maker’s recommended arrangement.
Patio fire tables and outdoor fireplaces face rain, needles and spiders through our long wet season. If yours will not light after sitting, burns small or has a flaky remote, we clean it out and repair what failed.
No light after a wet spell
Small, weak flame
Remote or switch trouble
Spiders in the burner
Moisture or debris in the burner and igniter is the usual cause after a wet spell. Cleaning them out and checking the gas supply typically gets it lighting again.
It is a smart move. A pre-season visit catches clogged burners, weak igniters and small leaks before guests arrive, so the first fire of the year goes smoothly.
Phone us or use the form. Tell us the brand and what it is doing.
We diagnose, explain the fault and quote it. We begin only after you say yes.
We repair it, test the flame, check for leaks and tidy up before we go.
A little yearly attention keeps a gas fireplace lighting on the first try, especially before the stormy months set in.
Book a checkup in early fall, before the first windstorm, so the fireplace is ready as backup heat if the lights go out.
Use a cleaner made for fireplace glass and only when it is cool. Harsh sprays leave a film that bakes on.
Remotes and battery backups run on fresh cells. Swap them each fall so an outage does not catch you off guard.
Keep curtains, blankets, firewood and storage boxes well back from the unit and its vent, since a gas fireplace gets very hot.
A gas fireplace vents exhaust outside, and a worn gasket, blocked vent or cracked glass can let carbon monoxide into the room. You cannot see or smell it. Keep working CO alarms near bedrooms and on every floor, test them monthly and schedule a yearly inspection. If an alarm sounds, get everyone outside and call 911.
Gas fireplaces rarely fail without hints. Sensors and valves wear down slowly, and an early visit costs less than waiting for a total no-start. Watch for any of these warning signs:
If you smell gas: light nothing and touch no switches. Leave the house, then call 911 or Puget Sound Energy at 1-888-225-5773 from outside. On propane, call your supplier too. Call us afterward at (425) 225-4756.
A yearly visit cleans the pilot and glass, checks for gas and carbon monoxide, and gets your fireplace ready for the first stormy night in Granite Falls.
Just want one tune-up this year? Book a single visit online or call us.
Yes. Many rural Granite Falls homes use propane, and the repair work is similar. We confirm the fuel type and burner setup so the unit runs the way it was built to.
We do. That includes Lochsloy, Lake Roesiger, Menzel Lake, Robe Valley and the Mountain Loop area. Our shop is in Lake Stevens, a short drive along SR 92.
A wall switch, a weak thermopile or a failed valve can all stop the main burner. We test them in order so only the faulty part gets replaced.
Yearly is the standard advice, ideally before the stormy season starts. A checkup covers the burner, pilot, glass seal, venting and a leak test so surprises are rare.
Yes, as long as it is a gas-fired appliance. Manufactured homes have their own venting rules, so we look closely at the vent path and the clearances.
A sealed, direct-vent unit can be a good backup, but only when it works properly and vents well. Have it inspected before the first big windstorm arrives.
